Washer and Dryer Removal in Boise: Getting It Up the Stairs

A lot of washer and dryer removal jobs in Boise start the same way. The machine quit mid-cycle, it's still holding water, and it's parked at the bottom of a basement staircase somebody framed decades ago without picturing a heavy appliance coming back up it.

Older stairwells around Hyde Park and the North End are often narrow, with a hard turn at the bottom. If a front-load washer went down there with a few people and a lot of patience, expect it to take about the same to get back out.

When the pair sits in a main-floor laundry room close to the garage, it's a quick job. Basement laundry is a different job.

Here's what actually happens down there, and what you can do ahead of time to speed it up.

Why washer and dryer removal is harder in older Treasure Valley homes

Newer builds in Meridian and Nampa usually put laundry on the main floor or in a wide upstairs closet. Those are easy days for us.

Older homes are another story. A lot of the housing in the North End, on the Bench, and around downtown Nampa has basement laundry, and those stairs were built narrow on purpose. Every spare inch went to living space instead of the stairwell.

So which part actually causes the trouble? Two things: the width of the treads, and the turn at the landing.

A straight run you can manage. A 90-degree turn at the bottom means the machine has to pivot in a space that's often shorter than the machine is tall.

Weight matters too. A top-load washer is heavy, and the dryer is usually the lighter of the two.

A front loader is heavier still. That's the concrete counterweight bolted inside, the thing that keeps it from walking across the floor on spin cycle.

So a front-load pair in a basement is a lot of appliance coming up a staircase. That's why we send two people instead of one.

What to do before we show up

None of this is required. We'll handle all of it if you'd rather not touch anything. But each one saves time on the clock, and a couple of them save your stair carpet.

• ✓Shut the hot and cold valves behind the washer all the way off
• ✓Pull the drain hose out of the standpipe and let it empty into a bucket
• ✓Unplug both machines and set the cords on top so they don't drag
• ✓If it's a gas dryer, close the gas valve behind it (not sure which valve? Leave it alone and tell us)
• ✓Clear the path: laundry baskets, the litter box, the stack of stuff on the third step
• ✓Prop the storm door open or pop it off its hinge pin

Tip: A washer that died mid-cycle can still be holding water in the drum and the pump. Tip it back onto the rear corners over a shallow pan and let it drain before anybody picks it up. Otherwise it soaks whoever's on the low end of the stairs, and it runs straight down the carpet behind them.

Wondering how far to go with the disconnecting part? We wrote a whole post on it: [do you unhook it yourself?](/blog/appliance-removal-boise-who-disconnects-it) Short version, water lines and cords are fine to handle yourself, and gas lines are worth leaving to somebody licensed.

Stairs, doorways, and the turn at the bottom

When we get there, the first thing we do is walk the route backward. Basement floor, up the stairs, through whatever door is at the top, out to the truck.

We're looking for the tightest point, and it's almost never the stairs themselves.

Usually it's a door casing. A standard interior door is 30 or 32 inches, and a washer is about 27 wide, plus the dolly, plus knuckles.

That's tight. Pulling the door off its hinges buys a little extra room on each side, and it only takes a few minutes with a screwdriver and a hammer.

We run an appliance dolly with a strap around the machine, one person controlling from above and one below taking the weight. Moving blankets go over the machine and sometimes over the stair nosing.

The thing that gets damaged on these jobs isn't the appliance you're throwing away. It's the drywall at the turn and the railing spindles.

Honest note: if your stairwell is especially narrow with a switchback, sometimes the smarter move is out through a basement egress window instead. We've done it a few times. It's not exotic, it just takes a plan.

What washer and dryer removal costs in Boise

For a single appliance on the main floor, the price comes down to how much truck space it takes and how easy it is to reach. A washer and dryer together cost more than one machine, but since pricing is by volume, the second unit usually adds less than the first.

Basement stairs can add to it, depending on the run and the turn. If we're already at your house pulling other stuff, the appliances usually fold into the load price and cost less than a standalone trip would.

Compare that to renting a dolly, talking a friend into helping, and driving out to Hidden Hollow at the Ada County landfill on a Saturday morning. You're paying for the rental and the disposal fee by the time you're done, plus your morning, plus the risk to your back and your stairwell.

Plenty of people do it that way and it goes fine. Others find out halfway up the stairs that it's harder than it looked.

Where it all ends up: machines that still run can go to a resale floor like Idaho Youth Ranch, and the dead ones get stripped for metal at Western Recycling instead of buried. Steel cabinet, motor, drum, all of it has scrap value.

Refrigerators are the one appliance with an extra step, and we covered [why the refrigerant matters here](/blog/refrigerator-removal-boise-freon).

How long most [appliance removal](/junk-removal/appliance-removal) jobs across Boise, Meridian, and Nampa take on site comes down to the route out: how far, how narrow, and how many turns.

Bottom line

Pulling a washer and dryer out of a Boise basement isn't complicated. It's just heavy and awkward, and the risk is to your house more than the machine.

Drain it, unplug it, clear the path, and let somebody else take the stairs.

Want a straight number before you commit? Call or text us at (208) 593-2877 with a photo of the machines and the stairwell. We'll tell you what it runs, and if it's honestly a two-person DIY job, we'll say that too. The [appliance removal](/junk-removal/appliance-removal) page has the rest whenever you're ready.